Advertisement
GRAND EFFECTS
OPERATING AND MAINTENANCE INSTRUCTIONS
For your safety:
If you smell gas:
1. Shut off gas to the appliance
2. Extinguish any open flame
near unit.
3. If odor continues, immediately
call your gas supplier
This manual should remain with the homeowner or parties responsible for operation.
(RevH)
Fire Pit Inserts
(Automated) Model 100A
INSTALLATION GUIDE
For your safety:
Do not store or use any gasoline or
other flammable vapors and / or
liquids in the vicinity of this or any
other appliance.
Advertisement
Related Manuals for GRAND EFFECTS 100A
Summary of Contents for GRAND EFFECTS 100A
-
Page 1: Installation Guide
GRAND EFFECTS Fire Pit Inserts (Automated) Model 100A INSTALLATION GUIDE OPERATING AND MAINTENANCE INSTRUCTIONS For your safety: For your safety: If you smell gas: Do not store or use any gasoline or 1. Shut off gas to the appliance other flammable vapors and / or 2. -
Page 2: Table Of Contents
Table of Contents Gas and Electrical Requirements Page 3 Installation of Fire Pit Insert Page 6 Burner Setup and Adjustment Page 8 Maintenance Page 9 Operation Page 9 Spare Parts Page 10 Troubleshooting Guide Page 11 Control Panel Wiring Diagram Page 12 Burner Assembly Wiring Diagram Page 13... -
Page 3: Gas And Electrical Requirements
Typically, the pool controller is the device that turns the unit on/off. If a pool controller is not available, Grand Effects can provide a hand held remote system or an electrician can wire a decorative switch for on/off control upstream of the Grand Effects Control Panel. - Page 4 IMPORTANT!! Note: 18” Minimum Depth Requirement of Fire Pit (as shown in Fig. 4 and Fig. 5) Venting is required for cooling Burner Assembly (as shown in Fig. 4 and Fig. 5) Set up for Natural Gas Fig. 1 Set up for Propane Gas Fig.
- Page 5 Fig. 3 (Commercial Installation) Important: Do not kink or make sharp radius on metal gas hose. Do not come straight up with gas hose. As shown below, a 90 gas pipe elbow must be installed on gas line for proper installation of gas hose. If not installed with elbow as shown below, product warranty will be void.
-
Page 6: Installation Of Fire Pit Insert
Installation of Fire Pit Insert Install Burner Assembly as shown in Figure 6. The Burner Assembly shall be centered and supported by the “SUPPORT Plate”. Connect Gas Hose to Burner Assembly as shown in Figure 6. Install wire nuts on wires from Control Panel and Burner Assembly. Be careful to hook up the “positive”... - Page 7 Fig. 7 (Propane-Commercial) Fig. 8 (Natural Gas)
-
Page 8: Burner Setup And Adjustment
Burner Assembly and Support Plate. Fire Glass requires a Glass Pilot Hood, which is different than standard Pilot Hood used with lava rock. Please consult Grand Effects Glass Install Manual. If you use ¼” pieces of lava it should be treated as a glass installation. -
Page 9: Maintenance
Before any inspection of the unit, always turn off power and gas supply at the Control Panel. If you experience problems with this unit, call Grand Effects or a licensed heating professional. All work on this unit shall be performed by a licensed heating... -
Page 10: Spare Parts
Caution! Before you turn on the Grand Effects System, make sure that it is clear or people, animals or any objects that are combustible. Operating Instructions: To turn unit “On”: 1. Turn Burner Power “On”. To turn unit “Off”: 1. Turn Burner Power “Off”. - Page 14 Grand Effects Limited Warranty 1 Year Residential /6 Month Commercial Grand Effects will replace, at its expense, any unit, which in normal use, has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to Grand Effects with proof of product within one year and provides Grand Effects with reasonable opportunity to verify the alleged defect by inspection.