Daewoo DWM-800C Service Manual page 13

PROBLEM
Is the Motor hot? (In case there is
Thermal Protector)
The Spin
Dryer does
not spin.
Is the wiring good? (Refer to
Wiring Diagram)
Is the Door Switch Lever properly
placed on the Door Spin *O?
Is the Door Switch terminal prop-
erly connected?
Is the Contact of Spin Timer good?
Is the wash load well balanced?
Are clothes or the Safety Cover
stick out from Spin Basket?
There are
strange noise
and servere
vibration during
Is the assembly between the
spinning.
Drum Coupling Assembly and
Spin Motor or Spin Dryer loose?
Is the Spin Dryer itself well balanced?
12 THE REPAIR
CHECK POINT
Is the Condenser properly
connected?
YES
The Brake Band is touching
the Drum Coupling Assembly.
NO
NO
NO
YES
YES
YES
YES
YES
YES
NO
YES
CAUSE
NO
Motor does not start due to
opening the Condenser circuit.
YES
Brake wire is too long.
BRAKE SPRING is broken.
YES
Power has been cut off by
the Thermal Protector
NO
Improper wiring
NO
Defective connection
YES
Improper wiring
NO
Defective Spin Timer
Defective Spin Motor
NO
Spin Dryer does not balanced
due to wash load.
NO
Tub is in contact with the
object sticking out.
YES
Improper structural assembly
NO
Spin Dryer unbalance
SOLUTION
Reconnect.
Assemble after loosening
Wire Guide Screw and
adjusting downward.
Replace Brake Spring.
Power restored when motor
cools.
Reconnect wiring
Replace Door Switch or
reshape the Lever.
Reconnect the terminal.
Replace the Spin Timer.
Replace the Spin Motor.
Reload the clothes so they
are well balanced
Reload the clothes and
press down the Safety
Cover into Spin Basket.
Tighten the Bolt Drum
Coumling Assembly.
Re-assemble Spin Dryer.