Jabra Stone User Manual page 14

I cannot hear music in the headset
- ensure that the headset is connected to your
enabled device
- You may have been out-of-range (10 meters) to your
enabled device or the headset might have experienced an
eSD (electrostatic discharge) incidence . Press the answer/end
button to re-establish the
- Increase the volume on your device
- Make sure that the Jabra Stone is charged
- turn the headset off . Wait a couple of seconds, press the answer/
end button until yellow light comes on . Set your phone to
discover Jabra Stone and your phone will find it . Connect and
you should now be able to listen to music
The music I hear sounds very poor
Make sure the other device supports
including the advanced audio Distribution Profile (a2DP) for
music streaming . If the above procedure did not help then it is
possible that your phone is using the stereo audio connection
in a different way . You can enable this mode on Jabra Stone by
performing pairing in the following way:
- remove the
phone
- Make sure the headset is charged
- take the headset out of the portable charging unit
- Press the answer/end button for 10-15 seconds until the
connection indicator shows solid yellow light
- Go through the regular steps in pairing the headset to a
device
be aware that standby time of the Jabra Stone can be lower when
using this pairing compared to the regular one .
The music player starts immediately upon connection and
I hear music in the headset
- turn the headset off . Wait a couple of seconds, press the answer/
end button until yellow light comes on . Set your phone to
discover Jabra Stone and your phone will find it . Connect and
music should start only when asked for .
audio link
connection to Jabra Stone on your
Jabra Stone
1 .1 or higher
11