Assembly - Craftsman 315.115940 Operator's Manual

ANTENNA
COVER
WIRE
ANTENNA
TUBE
INSTALLING THE TRUCK ANTENNA
See Figures 2 - 3.
The truck antenna must be installed before use. The
antenna fits into a tube on the truck's chassis.
To install the antenna, the truck body must be removed.
 Place the truck on a flat, stable surface.
 Pull out the four pins that secure the truck body and
set them aside.
 The antenna wire is threaded through the hole on the
truck body. Remove the truck body.
 Slide the wire cover back toward the chassis to take
out some of the slack in the antenna wire. You can tie
a loose knot near the top of the antenna wire to secure
the wire cover. Do not pull on the antenna wire where it
is attached to the chassis.
 Insert the antenna and its wire into the antenna tube on
the chassis, making sure it is secure.
To replace the truck body:
 Thread the antenna through the hole in the truck body.
 Position the truck body over the four mounting posts
on the chassis.
 Reinstall the four pins that hold the truck body, making
sure the pins are securely in place before operation.
NOTE: Never operate the truck while the body is re-
moved. Doing so may cause damage to the chassis or
other internal parts.
WIRE
MOUNTING
POST(S)

ASSEMBLY

CAUTION:
antenna wire is not contained in the wire cover.
Check before each use to be sure the antenna is securely
attached.
ANTENNA
8
Do not attempt to operate the truck if the
TUBE
ANTENNA
WIRE
WIRE
COVER
PIN(S)
Fig. 2
ANTENNA WIRE/
WIRE COVER
Fig. 3