Advertisement
Receiver
Insert the DC Plug of AC Adaptor in to the receiver.
Insert AC Adaptor into the socket of AC mains
supply.
To DC Socket
of Receiver
12
Insert one end of connecting cable to Audio Output
socket of Receiver and other end of the cable to
the Mic input of an amplifier.
Ensure both the telescopic
antennas are fully extended
vertically.
Switch ON the Power Switch of
the Receiver. Red LED on front
panel will glow.
Always keep the receiver antennas away from
metal and other reflecting surfaces and
obstructions.
• Operation & Battery Insertion
Hand-held Microphone
Insert a 9V battery in the battery compartment of
the hand-held microphone by unscrewing the lower
part of the microphone body.
To AC mains
Ensure the 9V battery is inserted with correct
polarity.
The microphone has a 3-position slide switch:
To Audio Output
9
of the Receiver
To Mic Input
of an Amplifier
In top position, the microphone is ON and Red LED
glows.
The centre of the switch is 'Standby' or 'Audio
Mute'. In this position Red LED will glow, RF
Carrier frequency will be transmitted, but 'Audio'
will be muted.
When the switch is at the lowest position, the
microphone will be completely switched off.
Frequency
ON
ON
OFF
OFF
Top Position
Centre Position
Battery
9V
Battery
Unscrew
to open
Sticker
ON
OFF
Lowest Position
Advertisement
