Alternatively you can confi gure the speaker as a slave, with the D2 input used for all
sources, as follows:
• Press the green > (Play) key on the remote
repeatedly until the display shows:
When you have confi gured the loudspeaker:
• Switch off the 3100 loudspeaker, using the power switch on the back, and then
switch on again to restore normal operation.
Custom configuration
This mode allows you to check or alter the individual settings defi ned by the
standard Type settings.
• Turn off the DSP loudspeaker, using the power switch on the back panel.
• Turn on the power again while holding down the 0 key on the remote.
The display will show the current setting of the fi rst confi guration option.
• Press > or < to step between the options.
• Press A or V to change the value of the current option.
The table below shows the options you can confi gure:
Option
Position and master/slave
Compatibility (G, 500, 200 Pre, or 200 CD)*
Controller mode (Auto, Con, or NCon)
System address (1–8)
Diagnostic displays? (N or Y)
Product address (1–8)
Volume mode (1=normal, 2/3=second/additional
room)
Balance control? (N or Y)
Centre menus? (N or Y)
* G gives 500 Comms and MSR+ sources, 500 gives 500 Comms and MSR sources, and
200 Pre or 200 CD are legacy modes.
L.
Initial value in Type 1
L.
G.
Auto.
S.A. 1
Diag. N
P.A. 1
L.E. 1
Bal. Y
Centre menus? (N or Y)
Slv2