Before UPDATE the Digital Soft Firmware, it is necessary to install the WRITING TOOLS into the PC.
For the installation of WRITING TOOL, refer to the "INSTALL FOR WRITING TOOLS".
1.
Unplug the AC cord, and remove the back cabinet.
2.
Using the Serial Communication Change JIG (JG201) and RS232 Cable, connect the PC terminal and UART
Connector(CP2402) on the MAIN PCB.
MAIN PCB
Connect it in order of MAIN PCB
3.
Insert the AC cord, turn on the power.
4.
Press both VOLUME DOWN button on the set and Channel button (2) on the remote control for 2 seconds.
Confirm that displayed software version.
5.
Set the Standby mode.
6.
Set the DTV ROM DISC(JG176) to PC.
RE-WRITE FOR DIGITAL SOFT FIRMWARE
UART Connector(CP2402)
Serial Communication Change JIG(JG201)
Serial Communication Change JIG(JG201)
TO MAIN PCB
RS232 Cable
TO PC
C-4
RS232 Cable
PC.