Setting Up Sources - Meridian 562 User Manual

Setting up sources

For each of the twelve source selection keys on the Remote control you
choose a display Logo and a primary physical input connection – and by
implication – signal type. In addition for digital sources you may set up a
secondary analogue input connection that 562 may use for the analogue
tape copy signal. (This is necessary if you do not have the DAC option
fitted or externally connected – see page ??).
Normally as shown we set the CD key to give a CD display with the D1
(Digital 1) input selected. You may however wish to display CD1 for your
main CD player and to connect it to D2 or one of the analogue inputs.
A full list of possible logos and their meanings is:
Source Logo
CD CD
Radio RD
LP LP
Tape 1 T1
Tape 2 T2
CDR Cr
Cable Cb
Teletext TX
VCR 1 V1
VCR 2 V2
Laserdisc LD
Satellite SA
CDX C2
78 rpm 78
VHS VH
Choosing source logos
Note at any time in the source configuring process you can use the
handset Mute key to return to the root menu with a display like '500' or
'200'.
In Config mode:
1. Press Source until you see a Remote-key (source) + logo display like
CD CD
2. Press Source until the Remote key name for the source you wish to
configure is displayed.
3. Use the and Volume keys until the correct logo is indicated – see
the list above.
4. Make changes for all the source options.
Customising 562 using Config
Source Logo
S-VHS SV
Betamax m
Camera Ca
Video 8 V8
CD-Video CV
CD-I CI
CD trans. C1
Photo CD PC
CD Lib. CL
Jukebox JB
CD-ROM Rm
DAT DT
DCC DC
Phono Ph
MiniDisc VH
21
Source Logo
DAB DB
Dig. Sat. DS
ADC AD
R-Reel RR
FM tuner FM
AM tuner AM
MW tuner MW
SW tuner SW
LW tuner LW
Line Li
Mic. Mi
Aux Au
Mixer Mx
Simul. SB
Computer PC
562 User Guide