Hisense HR6BF47 User's Operation Manual page 16

Symptom
Appliance does not
work.
Appliance cools too
much.
The food is too
warm.
Heavy build-up of
frost, possibly also
on the door seal.
Unusual noises.
The compressor
does not start
immediately after
changing the
temperature
setting.
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or
is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not
air-tight(possibly after
reversing the door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if
necessary.
Mains malfunctions are to
be corrected by an
electrician.
Turn the temperature
regulator to a warmer
setting temporarily.
Please look in the "initial
Start Up" section.
Open the door only as long
as necessary.
Turn the temperature
regulation to a colder
setting temporarily.
Please look in the
"installation location"
section.
Carefully warm the leaking
sections of the door seal
with a hair dryer(on a cool
setting). At the same time
shape the warmed door
seal by hand such that it
sits correctly.
Readjust the feet.
Move the appliance
slightly.
If necessary, carefully bend
the component out of the
way.
The compressor starts
after a period of time.
14