Time/Date - Mercedes-Benz 2010 GLK-Class Operator's Manual

Permanent display
You can use the Permanent Display:
function to choose to display either the
outside temperature or the speed in
kilometers (USA) or miles (Canada)
permanently.
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Instr. Cluster submenu.
X
Press button a.
X
Press button : or 9 to select the
Permanent Display: function.
The current setting is shown.
X
Press button a to change the current
status.
Depending on the previous status, the
Permanent Display: will be switched
between Outside temperature or
Speedometer (km/h) (USA)/
Speedometer (miles) (Canada).
Time/Date submenu
Access the Time/Date submenu via the
Settings menu. Use the Time/Date
submenu to change the time and date display
settings.
The following functions are available:
Setting the time ( Y
R
Setting the date ( Y
R
Setting the time
This function is not available if your vehicle is
equipped with the COMAND system and
navigation module.
Vehicles with COMAND system:
page 121)
page 121)
For information on setting the time in the
COMAND system, refer to the separate
COMAND system operating instructions.
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Time/date submenu.
X
Press button a.
X
Press button : or 9 to select the
Time function.
X
Press button a.
The current time appears in the
multifunction display.
X
To set a new time press button a again.
X
Press button = or ; to select the
setting you wish to change: hours or
minutes.
X
Press button : or 9 to change the
setting which is highlighted.
X
Press button a to store the entry.
Setting the date
This function is not available if your vehicle is
equipped with the COMAND system and
navigation module.
Vehicles with COMAND system:
For information on setting the date in the
COMAND system, refer to the separate
COMAND system operating instructions.
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Time/date submenu.
X
Press button a.
X
Press button : or 9 to select the
Date function.
Control system
Z
121