Table of Contents
Advertisement
Vehicle status messages in the multifunction display
232
X
Turn the crank handle in the direction of
arrow as far as it will go.
Operational position
X
Turn the crank handle clockwise.
Before placing the jack back into the vehicle
tool kit:
X
Fully collapse the jack.
X
Fold in the crank handle (storage position).
Spare wheel
G
Observe Safety notes, see page 279.
The spare wheel is located in the space
underneath the trunk floor.
X
Removing: Open the trunk (
X
Lift the trunk floor and secure it on the
upper trunk lip (
!
To prevent damage, always disengage the
floor handle from the upper trunk lip and
lower the trunk floor before closing the
trunk.
Y
page 76).
Y
page 230).
X
Remove luggage bowl ; by turning it
counterclockwise.
X
Remove spare wheel :.
Storing the spare wheel after use
X
Place spare wheel : into the spare wheel
well.
X
Secure spare wheel : by turning luggage
bowl ; clockwise.
Vehicle status messages in the
multifunction display
Notes
Warning and malfunction messages appear in
the multifunction display located in the
instrument cluster.
Certain warning and malfunction messages
are accompanied by an audible signal.
Address these messages accordingly and
follow the additional instructions given in this
Operator's Manual.
High-priority messages appear in the
multifunction display in red color.
Certain messages of high priority cannot be
cleared from the multifunction display using
a or % on the multifunction steering
wheel (
Y
page 112).
Other messages of high priority and
messages of less immediate priority can be
cleared from the multifunction display using
a or %. They are then stored in the
vehicle status message memory
(
Y
page 120). Remember that clearing a
message will only make the message
disappear. Clearing a message will not
correct the condition that caused the
message to appear.
G
Warning!
All categories of messages contain important
information which should be taken note of
and, where a malfunction is indicated,
Advertisement
Chapters
Table of Contents
