Assembly And Set-Up - Razor dirt rocket MX350 Owner's Manual

asseMBly anD seT-up

q attaching the Handlebars MX350 & MX400
Tools required: 6mm L-wrench
1
Place the handlebars in the
handlebar clamps.
q attaching the front fender
Tools required: 10mm and 5mm wrench
1
Align fender with the hole
in the fork and insert the
bolt. TIghten securely using
a 10mm Wrench and 5mm
Allen Wrench.
q attaching the number plate
Tools required: Philips screw driver
1
Remove screw from front
fork. Align the number plate
with the hole in the fork and
tighten with a Philips screw
driver.
2
Align parallel to the fork and
tighten the bolts using a 6mm
L-wrench. When properly tight-
ened, the handlebars should not
move forward or back.
3
warnIng:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.