INSTALLATION
AND
OWNER'S GUIDE
INSTAllER
MUST lEAVE
INSTRUCTIONS
WITH THE OWNER AFTER INSTAllATION
IMPORTANT:
Installer
must have owner
fill out and mail warranty
card supplied
with heater.
GENERAL INFORMATION
This series is design certified
by the CSA Laboratories
as an
Unvented Heater, and must be lnstalled
according
to these
instructions.
This appliance
is intended for supplemental
heating.
ANY ALTERATION
TO THE ORIGINAL DESIGN, INSTALLED
OTHER THAN AS SHOWN IN THESE INSTRUCTIONS,
OR
USED WITH A TYPE OF GAS NOT SHOWN ON THE RATING
PLATE IS PROHIBITED
AND VOIDS THE WARRANTY.
The installation
must conform to local codes.
In the absence
of local codes, the installation
must conform
to the National
Fuel Gas Code, also known as NFPA 54 and ANSI Z223..1 -
latest edition.
Installation and service must be performed by a qualified,
installer (i.e., a licensed heating contractor or gas company
personnel).
THIS IS A HEATING APPLIANCE.
ANY SAFETY SCREEN OR
GUARD REMOVED FOR SERVICING AN APPLIANCE MUST BE
REPLACED PRIOR TO OPERATING THE APPLIANCE.
"'WARNING:
If the information
in this manual is not
followed exactly a fire or explosion may result causing
property damage, personal injury or loss of life.
-I
Do not .store
or use gasoline
or other
flammable
vapors
and liquids
in the vicinity
of this or any other
appliance.
WHAT TO QO IF YOU SMELL GAS
.Do
not try to light any appliance.
.Do
not touch any electrical
switch;
do not use any
telephone
in your building.
.Immediately
call
your
gas
supplier
from
a
neighbor's
telephone.
Follow the gas supplier's
instructions.
.
.If
you cannot
reach your gas supplier,
call the fire
department.
Installation
and
service
must
be performed
by a
qualified
installer,
service agency or the gas supplier.
43126140
Jul/04
Need help?
Do you have a question about the CK6M-4-NG and is the answer not in the manual?
Questions and answers