Mercedes-Benz 2006 S 350 Operator's Manual page 406

Take the two-piece wheel wrench out
of the vehicle tool kit tray. Assemble
wheel wrench.
On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
The tube openings are located directly be-
hind the front wheel housings and in front
of the rear wheel housings.
1 Jack support tube cover
Remove cover 1 from the jack sup-
port tube by inserting a screwdriver
(supplied in vehicle tool kit) in the
opening as shown and prying it out.
Remove cover 1 carefully to avoid
damage to the locking tabs.
Practical hints
1 Jack support tube hole
2 Jack arm
3 Crank
Insert jack arm 2 fully into tube
hole 1 up to the stop.
Warning!
Insert the jack arm fully into the jack sup-
port tube hole up to the stop. Otherwise the
vehicle may fall from the jack and cause per-
sonal injury or damage to the vehicle.
Flat tire
G
405