Installation Instructions - Danby DPA080C2SDB Owner's Use And Care Manual

Installation Instructions

LOCATION
WINDOW SLIDER KIT
INSTALLATION
• The air conditioner should be placed on a fi rm foundation to minimize noise
and vibration. For safe and secure positioning, place the unit on a smooth, level
fl oor strong enough to support the unit.
• The unit has casters to aid placement, but it should only be rolled on smooth,
fl at surfaces. Use caution when rolling on carpeted surfaces. Use caution and
protect fl oors when rolling over wood fl oors. Do not attempt to roll the unit over
objects.
• The unit must be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or outlet of the unit.
• Allow at least 30 cm of space away from the wall for effi cient air conditioning.
NOTE: If the window opening is less than the mentioned minimum length of the
window slider kit, cut the end without the hole in it short enough to fi t in the window
opening. Never cut out the hole in window slider kit (visit www.danby.com for
general instruction videos).
Your window kit has been designed to fi t most "vertical" / "horizontal" windows up
to a maximum height of 80" (203 cm). For vertical window applications, multi lock
positions are provided on the edge of each slider section to secure each sliding
section together.
1. Select a suitable location, making sure you have access to an electrical outlet.
2. Install the fl exible hose to the rear of the unit. Insert the hose collar on top of
the exhaust opening.
3. Install the adjustable Window Slider Kit as required.
4. Install the opposite end of the fl exible exhaust hose into the window exhaust
adapter.
5. Install the window exhaust adapter into the opening in the slider section, mak-
ing sure the window slider sections are secure.
6. Plug the unit into a 115V/60Hz grounded electrical outlet.
Adjusting Plate
Screw
6
Cut if needed
Connector C
Screw