Advertisement
Switching to auto
Ensure the thermostat and/or the heat selector are set for the desired
heat output.
Check that the clock shows the correct time of day. Set the mode slide
switch to
, the heater will switch ON and OFF according to the timer
settings (see Fig. 9).
Important notes
Remember to observe all safety warnings when operating the heater on
auto setting unattended or attended .
If the mains supply to the heater is interrupted, the timer clock will stop until
power is restored ; reset the time of day to ensure correct ON and OFF times.
Turbo fan(selected models)
The turbo fan is used to boost
the airflow around the room. This
circulates the heat better and
results in a reduced heat up time
and a more even heat distribution.
The turbo fan is controlled by the
neon switch on the front of the
product.
The turbo can be turned on
independently of the heat,
however the fan will switch on
and off under the control of the
thermostat.
Note: on selected models in warm weather the fan can be used to circulate
cool air. Once the heat selection switches are in the off position and the
thermostat is set to 'Max' the fan will continue to function to circulate cool air.
Safety – overheat protection
For your safety, this appliance is fitted with a thermal cut-out. In the event
that the product overheats, the cut-out switches the heater off automatically.
To bring the heater back into operation, remove the cause of the overheating,
then unplug or turn off the electrical supply to the heater for a few minutes.
When the heater has cooled sufficiently, re-connect and switch on the
heater.
Important Notes
Although this heater is manufactured to comply with the relevant safety
standards, certain types of carpets could become discoloured by the
temperatures under a portable heater. If you are concerned about this,
we recommend that you contact the carpet manufacturer for guidance.
Alternatively, either stand the heater on a suitable base to shield the carpet
or wall-mount it – call our Helpline for further advice.
Fig. 7
You may notice some parts of the element appearing to be hotter from time
to time because of the variable airflow through the heater. This does not
cause a safety hazard.
The heat outlet grille may become discoloured with use – this is caused by
airborne pollution and is not a fault.
Fig. 8
Advertisement
