Table of Contents
Advertisement
W-500
W-500™ Control includes all of the standard features, in a new design that is
compatible with a number of Casablanca fan Models . The W-500™ hand-held
remote provides three forward or reverse fan speeds, full spectrum light dimming
and has an optional wall bracket. The W-500™ may be used alone to control
several fans or with extra controls to operate a single fan from different locations.
W-500
CONTROL
(TRANSMITTER)
W-500™
CAUTION! Do not use with wall dimmer or rocker switch.
Rocker
Switch
NOTE: - If a ROCKER SWITCH is being use to con-
trol the fan location, it must be changed to a STAN-
DARD SWITCH as shown.
Casablanca Fan Co. - Factory Service Department - Technical Library
FILE NAME ( W500WallControl.pmb) ras 07-09-04
™
W-500™ INSTALLATION
W-500
CONTROL
HOLDER
CONTROL BRACKET INSTALLATION
Standard Switch
12V BATTERY
DRYWALL
ANCHOR
6-32 (2)
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Install and tighten screws by hand only.
1
W-500
(Transmitter)
SCREW
WOOD SCREW
6-32 X
1" (2)
SCREW
6-32 X 1"(2)
Wall Controls - CONTINUED
3
/
" (2)
8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Casablanca W-500
Summary of Contents for Casablanca W-500
- Page 1 W-500 ™ W-500™ Control includes all of the standard features, in a new design that is compatible with a number of Casablanca fan Models . The W-500™ hand-held remote provides three forward or reverse fan speeds, full spectrum light dimming and has an optional wall bracket.
- Page 2 (2) this device must accept any interference, including interference that may this equipment. cause undesired operation of the device. Wall Controls - CONTINUED Casablanca Fan Co. - Factory Service Department - Technical Library FILE NAME ( W500WallControl.pmb) ras 07-09-04...
- Page 3 LIGHT button. Release the but- ton when the desired level is reached. Casablanca Fan Co. - Factory Service Department - Technical Library FILE NAME ( W500WallControl.pmb) ras 07-09-04...
- Page 4 IMPORTANT! When you change jumper switches, make sure the battery is not connected to the transmitter. Step 3. Install a fresh 12-volt battery into the transmitter. Casablanca Fan Co. - Factory Service Department - Technical Library FILE NAME ( W500WallControl.pmb) ras 07-09-04...
- Page 5 Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change. Step 2. Open the battery door of the W-500 control and remove the batteries. Step 3. Change the jumper switch settings, assuring that they are different from the previously installed fan.
- Page 6 Note: Any changes or modifications to the transmitter or receiver not expressly approved by Casablanca Fan Company may void one’s authority to operate this remote control. Casablanca Fan Co. - Factory Service Department - Technical Library...
Need help?
Do you have a question about the W-500 and is the answer not in the manual?
Questions and answers