Step 3: Install The Swivel Or Vent Mount - XM XMp3 Installation Manual

Vehicle Installation

Step 3: Install the Swivel or Vent Mount

You can use either the included swivel mount or vent mount for your XMp3 radio depending
on your vehicle interior .
Installing the Swivel Mount
CAUTION! The adhesive used with the swivel mount may make it difficult to remove .
Do not install this mount on leather surfaces and make sure the air temperature is at least
60°F (15°C) during installation .
1 Locate a flat surface for the mount . Make sure there is ample room for the XM
cradle and radio when installed .
2 Clean the surface with the preparation kit and let it dry thoroughly .
3 Peel off the adhesive liner . Position, press, and hold the swivel mount in place
for 30 seconds .
IMPORTANT! Let the adhesive cure for 24 hours before attaching the XM cradle and
radio to the mount .
Turn the swivel to accommodate the XM cradle and radio . Adjust the tension
4
via the center screw .
10
You can adjust this screw
to adjust the tension of the
mount with a screwdriver .