Hitachi BD-S5500 Operating Instructions Manual page 95

Troubleshooting
Symptom
Laundry sticks
to the walls of
the drum after
operations.
Are you running the [SILENT] program?
Water is consumed
Is the Water Cooling Mode set?
during drying
operations.
When adjusting the
Is <SPIN (1 MIN)> set?
spin speed, [SPIN
LEVEL EXTRA]
cannot be set.
The
[POWER SAVE]
and [POWER SAVE
Is the Water Cooling Mode set?
STATIC DRY]
programs cannot
be selected.
Did the laundry gravitate to one side during the
spin operation?
Did you add additional laundry during a wash
operation?
Operation time is
long.
Did you add excessive amounts of detergent?
Is the <HOT WASH> function set?
Is the <AUTO SELF CLEAN> operation set?
94
(continued)
Possible cause
Does the laundry stick regardless of the
above?
Depending on the operating environment and
pipe conditions, some water may be consumed.
When the spinning time is set to 1 minute, only
[REGULAR] or [MILD] can be set.
If so, the operation time will be longer, as
an operation to correct this is automatically
added.
If you add laundry while an operation is in
progress, the increase to the original detected
weight may increase the operation time.
The actual operation time may differ from
the original remaining time indication, as it
changes depending on the type and size of
the laundry items and the temperature of the
air and water.
The remaining time indicator automatically
adjusts and may change during operations.
When excessive foaming occurs, operations
may be prolonged for up to 15 minutes, as
an operation to reduce foaming is performed
automatically.
When <HOT WASH> is in operation, the
operation time may increase automatically.
The rinsing time will be longer, as the cleaning
is performed during the final rinse cycle.
Solution
We recommend using a fabric softener.
This is not a malfunction.
This is not a malfunction.
For details on the air/water cooling
dehumidification modes, see (P. 74).
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
To run the [POWER SAVE] or
[POWER SAVE STATIC DRY] program, change
the dehumidification mode to Air Cooling Mode.
(P. 74)
Load laundry into the drum carefully to avoid
concentration on one side. (P. 21, 22)
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
Refer to the detergent indicator to determine the
appropriate amount of detergent.
This is not a malfunction.
For details on the <HOT WASH> function, see
(P. 72).
This is not a malfunction. (P. 4)
(P. 28, 29)