Safe Operation Of Carry-On - West Marine Carry-On 12025763 Installation, Operation And Warranty

Table of Contents

Advertisement

Safe Operation of Carry-On

1. Use cord labeled with LCDI or AFCI to connect to power
source (see warning).
2. Using the Carry-On is not recommended while the boat is
under way.
3. Prevent accidents or damage to Carry-On. Always carry
or move unit using the handles. Unplug at receptacle and
Carry-On control panel prior to moving.
4. Do not disassemble Carry-On.
5. Be certain the Carry-On has been properly installed
according to the Installation Instructions.
6. Physical and electrical conditions vary greatly from
location to location.
(a.) Be sure the electrical service is adequate and
equipped with a circuit breaker (15 amps minimum for
115V units).
(b.) Use a three-prong (grounded) power cord rated at 15
amps minimum for 115V units, with a length no longer
than needed to reach from the installed Carry-On to
a grounded, 3-wire receptacle on your boat, or to a
suitable grounded dockside outlet (order part number
LCDI25).
Figure 1:
Wiring Diagram
Carry-On Portable Cabin Air Conditioner
(c.) DANGER - SHOCK HAZARD! Do not, under any
circumstances, cut or remove the grounding prong from the
end of your power cord. Your Carry-On must be used with
a three-prong grounding power cord and connected to a
properly grounded and polarized three prong receptacle.
DO NOT USE AN ADAPTOR PLUG, OR A TWO BLADE
ADAPTOR PLUG THAT BYPASSES THE GROUNDING IN
ANY WAY!
(d.) It is always desirable to have your on-board or shoreside
receptacle protected by a time delay fuse or circuit breaker.
7. If the Carry-On operation is interrupted (turned off, plug
pulled out, thunderstorm, etc., accidentally or otherwise)
after operation in the COOL mode, WAIT 3 MINUTES
BEFORE RESTARTING. This allows pressure inside the
compressor to equalize. Consequences of attempted restart
within the 3 minute period may be a tripped circuit breaker
or blown fuse. In this case, turn Carry-On to "OFF", reset
breaker (or replace fuse), wait 3 minutes, then restart.
8. If the Carry-On has been stored in any position other than
upright within 10 degrees of level, then, after installing, wait
30 minutes to allow compressor oil to settle to the bottom of
the compressor. Otherwise permanent damage may occur,
voiding the warranty.
5
• English

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents