Problems Solver - Tele System Hybrid BLOBbox Quick Manual

TELE System Hybrid BLOBbox

8 Problems solver

PROBLEM
1. The ON/ST.BY LED on the front
panel does not light up
2. No sound and/or image
3. The channels are not tuned.
4. The menu settings have not been
saved.
5. The remote control does not work.
6. The BLOBbox does not respond
when remote control
pressed.
7. TV recordings are cutted (ex. Last
minutes of registration are missed)
8. The TVBLOB number and PIN
have been forgotten.
9. The USB memory
recognized.
10. Video/audio/image files are not
played correctly.
12
POSSIBLE CAUSES
-The AC adaptor is not plugged in to
the electrical
BLOBbox.
-The AC adaptor is not working.
-The power switch is turned off.
-The SCART/HDMI
properly connected or is not working.
-The HDMI resolution output is not
compatible with your TV.
-Mute or low volume
-Wrong AV/HDMI video input selected
on TV
-Antenna signal is absent or low.
-Your antenna
compatible
terrestrial signal transmitted in your
area.
-You are using an antenna that needs
to be powered.
-Missed confirmation after a setting
change.
-The remote control is not pointed at
the BLOBbox.
-Flat or no batteries.
The batteries are inserted with
-
their polarities the wrong way.
-Momentary freeze of the BLOBbox.
button is -Remote control problems (see point
5).
- Broadcasters do not respect the
programs schedules.
is not -USB memory is not formatted in
FAT32/NTFS/EXT2 or EXT3
-USB memory not compatible with the
BLOBbox.
-File not supported.
socket or to the
cable is not
system is not
to receive the digital
COSA FARE
-Check that the AC adaptor is
properly plugged in.
-Check that the AC adaptor is well-
functioning.
-Turn on the power switch..
-Check the SCART/HDMI
connection and that the cable is
well-functioning.
on the remote control
-Press
and then press the green button, a
second LED will light up on the
BLOBbox's front panel. Press the
green button repeatedly with an
interval of about 10 seconds each
time until you see the interface on
the screen. Press SAVE (red
button) to apply the new resolution
video output.
- Increase the volume of the TV and
BLOBbox.
-Select the AV/HDMI input in which
the BLOBbox is connected.
-Call the aerial technician to check
your antenna system.
-Check that the antenna is powered.
-After every setting change, press
the button SAVE.
-Check that there are no obstacles
in front of the BLObbox.
-Insert new batteries.
Check the polarity of the batteries
-
as indicated inside the batteries
compartment.
-Unplug and restore the power
supply.
-When you schedule a recording,
add about 15 minutes to the end.
-Contact the technical
writing an e-mail
support@tvblob.com
-Format the USB memory using one
of these
FAT32/NTFS/EXT2 or EXT3.
-Try another USB memory.
-Convert the file to a compatible
format.
support
to
filesystems: