Heat & Glo HST-48D Owner's Manual page 29

F. Install Attic Insulation Shield
WARNING! Risk of Fire!
lation shield when there is any possibility of insulation or
other combustible material coming into contact with the
chimney
DO NOT pack insulation between the chimney and the
attic insulation shield
ailure to keep insulation and other materials away from
chimney pipe could cause re
DO NOT offset chimney inside insulation shield
WARNING! Risk of Fire!
materials that can de ect under humidity or other envi-
ronmental conditions is not recommended
You U T install an attic insu-
Use of cardboard or other
Bend inward
90°
Figure 8.6 Prepare Attic Insulation Shield
6 Tabs bent
Insulation
13 in.
(330 mm)
Figure 8.7 Install Attic Insulation Shield ( restop above ceiling)
6 Tabs bent
Insulation
13 in.
(330 mm)
Figure 8.8 Install Attic Insulation Shield ( restop below ceiling)
Bend remaining tabs
to rest against pipe to
prevent insulation
from falling in.
Insert three
screws
3 in. (76 mm)
overlap
Tabs bent in to
rest against pipe
Pipe
Attic Insulation Shield
17 in. (432 mm)
diameter
in 90°
Ceiling Firestop
Pipe
Insulation
Tabs bent in to
rest against pipe
Pipe
Attic Insulation Shield
17 in. (432 mm)
diameter
in 90°
Insulation
Ceiling Firestop
Pipe