Tv Basic Operation - Memorex MT2025D User Manual

1
2
Press the Power button 1 on the remote, or front of the
unit, to turn on the unit; the Power indicator will light green.
Press the INPUT button 2 repeatedly to select the TV
mode (the channel will appear in the display).
3
2
Adjust the volume level by pressing the VOLUME Up 1 or
Down 2 button.
NOTES:
• When ANTENNA option is set to TV, only channels up
to 69 can be chosen. When set to CATV, channels up
to 125 can be chosen.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
While in TV (NTSC) mode, the Reception option must be set to CABLE when using cable, see Step 2 above.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.
HEADPHONE JACK (SIDE OF UNIT)
For private listening, connect 3.5mm (32 ohm) stereo headphones (not included) to this jack. The speakers are automatically
disconnected when the headphone plug is inserted in the jack.

TV BASIC OPERATION

MUTE
1
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
0
-
ENTER
CH+
VOL VOL
MENU
- +
CH-
CC SLEEP FAV.LIST
GUIDE ARC CH.LIST
EXIT
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
0
ENTER -
CH+
1
VOL VOL
MENU
- +
CH-
FAV.LIST
CC SLEEP
ARC CH.LIST
GUIDE
EXIT
2
FOR TV MODE:
TV AIR: If using a VHF/UHF antenna with analog option.
TV CABLE: If using Cable TV with analog option.
FOR DTV MODE:
DTV AIR: If using a VHF/UHF antenna with digital option.
DTV CABLE: If using Cable TV with digital option.
Make sure that you chose the correct Reception option in
the Channel menu (see page 16).
NOTE: You can use the TV/DTV button on the remote to
choose between NTSC and ATSC options.
4
For proper operation, before selecting channels, they must be set into
the unit's program memory, see page 17.
Press and release the CHANNEL Up 1 or Down 2 button. The TV
automatically stops
into memory.
TV/CATV Direct Channel Selection buttons (0-9) 3
Use these buttons to select a channel. The channel number will
appear at the top right corner of the screen. Simply enter the 1, 2 or
3 digit channel number, followed by the ENTER button 4.
ATSC Direct Channel Selection buttons (0-9) 3
Use these buttons to select a channel. The channel number will
appear at the top right corner of the screen. Enter the main channel
number, then the - button 5, then enter the sub-channel, followed by
the ENTER button 4.
30
OPTIONS
MUTE
Q.VIEW INFO
INPUT TV/DTV
SAP P.MODE
0
ENTER -
CH+
VOL VOL
MENU
- +
CH-
FAV.LIST
CC SLEEP
CH.LIST
GUIDE ARC
EXIT
at the next channel set