Memorex MT1091 Owner's Manual page 7

ANTENNA CONNECTIONS
If you are using an indoor antenna (included) or an outdoor antenna (not included) follow
the instructions below that correspond to your antenna system. If you are using a cable
television service (CATV), refer to CATV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead
wire)
ANT
Transformer
(included)
CATV CONNECTIONS
ANT
Connecting an Internal Antenna
Your TV comes with an internal antenna.
Use it if you want to place the TV where
there is no outdoor connection.
1 Place the rod antenna (included) into the
antenna holder on the back of the TV
cabinet. Push it down until it locks in
place.
2 Connect the antenna leads (flat prongs)
to the two screws on the transformer (in-
cluded).
3 Push the round terminal on the back of
the transformer into the EXT. ANT. jack
on the back of the TV.
4 Extend and adjust the antenna.
75 ohm
OR
300 ohm
– 6 –
Connect the 75 ohm cable from combina-
tion VHF/UHF antenna to the antenna jack.
OR
If your combination antenna has a 300 ohm
twin-lead wire, use the 300-75 ohm match-
ing transformer (included)
For subscribers to basic cable service.
For basic cable service without a converter/
descrambler box, connect the CATV 75
ohm coaxial cable directly to the antenna
jack on back of the unit.
Antenna Holder
DC−12V
Rod Antenna
(included)
Antenna
Leads
Transformer
EXT.ANT.
UHF/VHF
(included)
IN
VIDEO
AUDIO