Using The Phu-60K; Connecting/Removing The Phu Connection Cable - Sony PMW-EX1 Operating Instructions Manual

To restore a card
Select "Execute" by turning the jog dial or
tilting the joystick then push the dial or
joystick.
The restore operation begins.
During restoration, the in-progress message and
status bar (%) are displayed, and the ACCESS
lamp is lit in red.
When restoration is completed, the completion
message is displayed for three seconds.
If restoration fails
• A write-protected SxS memory card or one on
which an error occurred cannot be restored. For
such a card, a warning message is displayed.
Release the write protection or replace the card,
as per the instructions in the message.
• An SxS memory card on which an error
occurred may become usable again through
repeated formatting.
• In some cases, only parts of clips cannot be
restored. Playback of the restored clips becomes
possible again.
• The following operation may restore an SxS
memory card for which the message "Could not
Restore Some Clips" is repeatedly displayed
each time you try the restoration process:
1
Copy necessary clips to another SxS memory
card, using the copy function (page 89) of the
camcorder or the XDCAM EX Clip
Browsing Software (page 117).
2
Format the problem SxS memory card, using
the format function of this camcorder.
3
Return the necessary clips to the SxS
memory card by copy operation.
Recording/playback during restoration
You can perform recording or playback using the
SxS memory card in the other card slot while
restoration is in progress.

Using the PHU-60K

You can use an optional PHU-60K Professional
Hard Disk Unit with this camcorder. The PHU-
60K incorporates a 60GB 1.8-inch hard disk, on
which up to 200 minutes of HD video can be
recorded in HQ mode.
Note
High-speed playback (page 84) may not be
properly achieved with the PHU-60K.
Connecting/Removing the PHU
Connection Cable
Recording/playback can be made using the PHU-
60K in the same manner as with SxS memory
cards by mounting the PHU-60K on the accessory
shoe of the camcorder and connecting the PHU
connection cable to an SxS memory card slot.
For the mounting method, refer to the instructions
supplied with the PHU-60K.
Connecting the PHU connection cable
1
Set the power switch of the camcorder
to the CAMERA position.
2
Open the cover of the card slot block
and plug the PHU connection cable into
a slot.
A C C E
S S
A
G
F U L L
A U T O
E B A
L
O P E
N
Insert so that the cable extends upward.
3
Turn on the PHU-60K.
The POWER indicator of the PHU-60K
lights in green.
S E L
M E N
B
U
S L O T
S E L E
C T
C H -1 C H - 1
A U
S E L
2
C H -
C H -2
Using the PHU-60K 35