Table of Contents
Advertisement
x
Securing the TV
To prevent the TV from falling, use the supplied screws, clamps and band to secure
the TV. Use only the supplied screws. Use of other screws may damage the TV.
screws
Screw the band to the TV stand and to the
provided hole at the rear of your TV.
x
Getting Started
Initial Setup
English
Language:
Select
Confirm
End
4
20 mm
3.8 mm
Step 1
Insert the batteries (supplied) into the remote.
Note
• Do not use old or different types of batteries together.
Step 2
Connect the antenna cable (not supplied) to 8
(antenna input) at the rear of the TV.
Tips
• Your TV can receive both TV and FM radio signal from the appropriate
connections through the 8 (antenna input) terminal (see page 9).
• You can also connect your TV to other optional components (see page 9).
Step 3
Plug in the power cord, then press ! on the TV to turn it on.
Note
• The 1 (standby) indicator flashes green for a few seconds when
turning on the TV. This does not indicate a malfunction.
Step 4
Set up the TV by following the instructions of the "Initial
Setup" menu (see page 5).
clamps
band
or
(1) Put a cord or chain through the clamps.
(2) Screw one clamp to a wall or pillar and
the other clamp to the provided hole at
the rear of your TV.
Advertisement
Chapters
Table of Contents
