Operation - RCA 900 MHz User Manual

Foldable stereo wireless headphone system with auto scan
Hide thumbs Also See for 900 MHz:
Table of Contents

Advertisement

HEADPHONE RECEIVER
1. Open the battery compartment cover on the right side of the
headphone receiver.
2. Insert two AAA size rechargeable batteries, noting the correct polarity
as indicated in the battery compartment.
3. Replace the cover by sliding it in place until it "snaps" into position.
4. The batteries must now be charged before you use the headphones.
Refer to the instructions on page 6 "Charging the Batteries" for
details.
The headphone may be operated by
using standard or alkaline batteries.
However, these may not be recharged in
the headphone. Standard zinc carbon,
manganese or alkaline batteries
may leak or explode if recharged in
the headphone, thereby voiding
the warranty. Do not attempt to
recharge any batteries in the head-
phone other than nickel cadmium
type cells that were included with
your unit.

OPERATION

1. Turn on the audio source (TV or audio component) to which the
transmitter is connected.
2. Slide the ON/OFF switch on the headphone to "ON."
3. Listen to the volume coming from the ear cups on the headphone to
make certain that the volume is not too loud before placing the unit
on your head. (See the section titled "Headset Safety" on page 1.)
Adjust the volume as needed using the VOLUME CONTROL wheel
located on the left ear cup. Once the volume level is at a comfortable
setting, place the headphones over your ears and adjust the volume
as desired.
4. If the best frequency reception is not found, press the "Auto Scan"
button on the headphone to locate the frequency of the transmitter
for the best reception. The stereo LED indicator will light up.
AAA
RECHARGEABLE
BATTERIES
RIGHT EARPHONE
4
BATTERY
DOOR

Advertisement

Table of Contents
loading

Table of Contents