Battery Installation; Fuses; Fuse Location - Triumph 900 Cruisers Owner's Manual

Battery Installation

• Ensure the Engine Control Module
(ECM) and its rubber cover are
correctly located behind the battery.
• Place the battery onto the battery
tray taking care not to touch the
terminals to the motorcycle.
• Reconnect the battery leads, positive
(red) lead first.
• Ensure the negative battery lead is
installed to the rear of battery
terminal as shown below.
3
2
T908045cUSA
1. Battery
2. Negative lead
3. Negative terminal fastener
• Apply a light coat of grease to the
terminals to prevent corrosion.
• Cover the positive terminal with the
protective cap.
• Install the battery
assemble the battery strap. Tighten
the battery strap
80 lbf in (9 Nm).
Maintenance and Adjustment
• Assemble the airbox cover and
finisher, tightening all fasteners to
26.5 lbf in (3 Nm). Ensure the
airbox cover stud is correctly located.

Fuses

Fuse Location

To access the fuses, ease the ignition switch
finisher outwards from the bottom. Once free
of its retaining grommet, hinge the cover
upwards and detach from the slot in the
bracket.
3
1
2
T908046USA
1. Ignition switch cover
2. Retaining grommet
3. Bracket slot
cover and
fastener to
1
85