Table of Contents
Advertisement
can be authorized to different permission levels to operate the network
camera.
2.1 Hardware installation
1. Connect the network:
Connect the networking camera to the router or switch.
2. Connect the power
Connect the networking camera with power.
Cautions: Please use the original power adaptor along with the camera;
otherwise, it may cause hardware damage.
3. Check the network indicator light
when power on, the camera starts working. Normally the green indicator
of the network cameras is on continuously and yellow light flashes.
2.2 Software Installation
Software installation is very simple, you only need to run ocx.exe and
installation can be finished automatically. There are two ways to install
software.
I: CD-ROM installation
1. Please put the attached CD into the CD-ROM driver in your PC.
2. Double-click ocx.exe and installation can be finished automatically.
Second: Download OCX.exe from the networking camera and install the same
1. When the software is not installed in your PC, meanwhile, the camera is
connected to the network, you will be prompted to download and install the
control software. You can download the same to any folder you want. After
downloading is completed, double-click OCX.exe and automatic installation
will be implemented. Downloading OCX.exe from the network camera is widely
Chapter 2 installation
Advertisement
Table of Contents
