Table of Contents
Advertisement
PROGRAMMING PROCEDURES
SECTION 500-036-300
JANUARY 1988
TABLE 11
PROGRAM
#4-CO
LINE IDENTIFICATION
(LCD EKT Required)
SET LED on.
1) Lock in the
SET
switch
on the HKSU.
Station
13/l
7 LED 19 on.
System
is in program
mode.
Normal
functions
halt on station
13/l
7.
LCD is in program
mode.
2) Depress
the m
key on station
13/l
7.
SPKR LED steady
on.
LCD: Program
No.?.
3) Dial 91 on the dial pad
SPKR LED flashes
continuously.
LCD displays
program
number.
4) Refer to the System
Record Sheet.
Cursor
appears
in LCD display.
Depress
the required
key, and enter
the CO
LCD displays
characters
as they are entered.
iine name,
as defir.ed
in the System
Record
Sheet,
via the dial pad.
a) Depress
the 3 key to access alpha charac-
ters.
b) Move the cursor to the desired position
(the
left edge of the display
for a new
message,
two spaces to the right of the preprogrammed
message
to add information).
c) Depress the key with a letter you wish to en-
ter. Use the 3 key to shift from
letter to letter
on the key. For example:
l
If you press 1 , a D will be displayed.
By
pressing
3, the D is changed
to E. Bypress-
ing a again, the E is changed
to F. Press a
again
and the F changes
to D.
l
To enter
spaces,
press fl .
d) If want
to enter
a number,
press the 1 key
to change
to numeric
characters.
Numbers
are also entered
on the dial pad. Press the 2
key again to return
to alpha characters.
e) The fo!!owing
specia! characters
are set by
pressingfland
then pressinglto
step through
the available
characters:
Q,
Z,
:, -, +, 1.
5) Depress
the m
key to place new
data in
All station
13/l
7 LEDs (except
19) go off.
memory.
6A) Return
to Step 2 in order to continue
with
this program
or . . .
6B) Go to Step 2 in'another
program
table
.
. or . . .
6C) Transfer
data into working
memory
per Par-
agraph
02.06.
SET LED goes off.
Station
13/l
7 LED 19 goes off.
New data is stored,
previous
data is erased.
-37-
Advertisement
Chapters
Table of Contents
