Realistic 31-2018A Owner's Manual

To connect a Realistic 10 Band Stereo Frequency Equalizer model 31-2008, follow these steps:

1. Turn off all equipment before making any connections.

2. Connect the equalizer between your receiver/amplifier and your tape deck or audio source:
- Use RCA cables.
- Plug the “Tape In” (or “Input”) jacks on the equalizer to the “Tape Out” jacks on the receiver.
- Plug the “Tape Out” (or “Output”) jacks on the equalizer to the “Tape In” jacks on the receiver.

3. Select the tape monitor function on your receiver to activate the equalizer.

4. Power on the devices and adjust the equalizer sliders to shape the sound.

Make sure left and right channels are connected correctly.

This answer is automatically generated

To connect a Realistic 31-2018A 10-band stereo frequency equalizer:

1. Turn off all equipment before making connections.
2. Locate the Tape Monitor loop on your amplifier or receiver (usually labeled "Tape In" and "Tape Out" or "Tape Monitor").
3. Connect the equalizer's input jacks to the "Tape Out" or "Rec Out" jacks of the receiver using RCA cables.
4. Connect the equalizer's output jacks to the "Tape In" or "Play In" jacks of the receiver using RCA cables.
5. Turn on the receiver and equalizer.
6. Activate the Tape Monitor switch on the receiver to route the sound through the equalizer.
7. Adjust the sliders on the equalizer to shape the sound as desired.

This setup allows the equalizer to process the audio signal before it reaches the speakers.

This answer is automatically generated