Ask Proxima A3100 Manual page 36

• Be extremely careful when removing the lamp housing. In the unlikely
event that the lamp ruptures, small glass fragments may be generated.
The lamp module is designed to contain most of these fragments, but
use caution when removing it. Before replacing a ruptured lamp, clean
the lamp compartment and dispose of cleaning materials. Wash hands
after lamp replacement. If replacing the lamp while the projector is
ceiling-mounted, wear protective eyewear.
Hg – Lamp contains mercury. Manage in accordance with local
disposal laws. See www.lamprecycle.org.
4
Loosen the captive screw that attaches the lamp housing to the
projector. Carefully remove the lamp housing. Dispose of the lamp in an
environmentally proper manner.
5
Install the new lamp housing and tighten the screw.
6
Re-attach the lamp connector to the projector.
7
Replace the lamp door by sliding it into place.
8
Plug in the power cord and press the Power button to turn the projector
back on.
9
To reset the lamp hour timer, navigate to the Status and Service menu
and select Reset Lamp Hours. See page 32 for details.
35
http://www.pureglare.com.au
loosen screw