Table of Contents
Advertisement
CRD3539A_Eng
9/21/01 4:43 PM
Tuner
Listening to the radio
1
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 10.
This unit's AF (alternative frequencies search)
function can be switched on and off. AF should
be off for normal tuning operation (refer to page
14).
1
indicator
BAND
Shows which band the radio is tuned to, MW,
LW or FM.
2
indicator
FREQUENCY
Shows to which frequency the tuner is
tuned.
3
PRESET NUMBER
Shows what preset has been selected.
4
() indicator
STEREO
Shows that the frequency selected is being
broadcast in stereo.
1 Press
to select the tuner
SOURCE
2 Use
to adjust the sound level.
VOLUME
Rotate to increase or decrease the volume.
Page 9
3
4
2
indicator
.
3 Press
to select a band
BAND/ESC
Press
until the desired band is dis-
BAND/ESC
played,
,
,
for FM or
F1
F2
F3
• The FM bands cover different frequency
ranges as below;
(FM1): 65 — 74 MHz
F1
(FM2) ,
(FM3): 87.5 — 108 MHz
F2
F3
4 To perform manual tuning, press 2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold 2
or 3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold 2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO ()
light.
<CRD3539-A>9
Section
03
.
.
MW/LW
indicator will
9
En
Advertisement
Table of Contents
