CRD3539A_Eng
9/21/01 4:44 PM
Initial Settings
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press
FUNCTION
Press
repeatedly until
FUNCTION
in the display.
on or off with 5/∞.
2 Select
AUX
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
AUX :ON
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press
FUNCTION
Press
repeatedly until
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
DIMMER
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
DIMMER :ON
Page 35
to select
.
AUX
appears
AUX
between on and
AUX
to select
.
DIMMER
DIMMER
between on
DIMMER
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press
to select
FUNCTION
2 Select the desired illumination color with
2/3.
Pressing 2/3 will switch
or green and that status will be displayed (e.g.,
).
ILL. CLR :GRN
Switching the rear output setting
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to Using subwoofer output on page 32).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
ting.
1 Press
to select the rear output
FUNCTION
setting mode.
Press
repeatedly until
FUNCTION
appears in the display.
• If the rear output setting has been set to the
subwoofer then
FRT+S/W
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
FRT+S/W
and that status will be displayed.
<CRD3539-A>35
Section
.
ILL. CLR
between red
ILL. CLR
FRT+REAR
will be displayed.
FRT+REAR
(subwoofer)
35
En
08