Asus P5B Premium Series Hardware User Manual page 160

5.5.3 JMicron
®
The JMicron
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
3. Microsoft
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install an internal Serial ATA hard disk drive and an external Serial ATA hard
disk drive on your system.
Install the internal Serial ATA hard disk drive to the SATA connector labeled
SATA_RAID or SATA_RAID1.
2. Set the JMicron Controller Mode item in the BIOS to [RAID]. See section
4.4.7 Onboard Devices Configuration for details.
Advanced
Configure Win627EHF Super IO Chipset
HD Audio Controller
Front Panel Support Type
Onboard 1394 Controller
Onboard PCIE GbE LAN_1
LAN Option ROM
Onboard PCI LAN_2
LAN Option ROM
JMicron SATA/PATA Controller
JMicron Controller Mode
Serial Port1 Address
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
5.6 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows
Always install the JMB363 driver before creating RAID sets.
5-48
®
RAID Configuration
Serial ATA controller allows you to configure RAID 0, RAID 1 and
® ®
Windows OS installation disk (Windows 2000/XP)
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
BIOS SETUP UTILITY
[Enabled]
[AC97]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[RAID]
[3F8/IRQ4]
®
OS had been installed.
Enable or Disable
High Definition Audio
Controller
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
®
OS installation. See section
Chapter 5: Software support