TK-80
1. Installing the AT unit (KAT-2: Option)
Remove the case and shielding cover in advance.
➊
1. Use screws (
) to install the Antenna tuner unit (KAT-2).
2. Before inserting the connector, cut the R101 wire.
3. Connect the lead with the connector like pull out to the
front side to CN11 (
4. Connect the coaxial cable's white-marked line to the
➌
X45's CN5 (
) (AT1) and the other line to CN6 (
(AT2).
5. Insert the flat cable from the tuner unit in CN6 (
control unit X53-3570-21.
6. Take care not to pinch the lead when reattaching the case.
2. Installing the selective call unit (KPE-1: Option)
Remove the case in advance.
1. Remove the two screws (
sides of the front panel, then loosen the two lower screws
➋
(
) half way and pull the front panel forward.
8
INSTALLATION
➋
) on X45-3620-21.
➊
) on the upper left and right
2. As shown in the figure, set the front panel down on its
face, mount the optional circuit board X52-330 (selective
call) and secure it with the four (
3. Connect the accessory flat cable (
3570-21 and CN2 on the KPE-1, then connect the acces-
sory lead with the connector (
➏
CN13 (
) on the X57-4660-21 (bottom side).
4. Take care not to pinch the lead when reattaching the case.
➍
)
➎
) of
➌
) screws.
➍
) to CN2 of X53-
➎
) to CN1 of the KPE-1 and