7) IDE Activity LED (2-pin IDELED)
This connector supplies power to the cabinet's IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE
connectors cause the IDE LED to light up.
A7V333
A7V333 IDE Activity LED
8) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting the single end to the board, connect the two plugs on the other
end to the floppy drives. (Pin 5 is removed to prevent inserting in the
wrong orientation when using ribbon cables with pin 5 plugged).
A7V333
A7V333 Floppy Disk Drive Connector
32
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
®
PIN 1
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
IDELED
FLOPPY
Chapter 2: Hardware information