Master audio LNC-12W User Manual page 10

Master Audio
1 - SPEAKON : All models use two Speakon terminals and are duly prepared for a
perfect connection in a parallel system.
WARNING: It is strongly recommended to use a two-conductor high quality wire, non-
2
shielded and two-coloured. We recommend to use a minimum section of 4mm for
each conductor.
Avoid long wire distances as they induce to important power and quality losses
2.2. Configurations
2.2.1. Full Range Stereo configuration
Connect each output of the amplifier LEFT/RIGHT to each cabinet using two wires,
independently.
Fig.2. Stereo configuration
2.2.2. Passive configuration with full range cabinets
There will be times when you will be interested in reinforcing your systems with LNC
subwoofers, in passive mode.
In this case one amplifier will be only used for the whole system.
In passive, connect one of the outputs of the amplifier to the subwoofer through a
wire.
Then, make a bridge from the slave Speakon connector of the subwoofer to its
respective mid-high satellite unit, always respecting the correct polarity between both
systems.
Do the same with the other channel.
It is also correct, if the installation requires so, to make the connection in the opposite
way, that is, from the amplifier to the satellite and then to the subwoofer.
LNC Series. Version 1.0 Feb 10
10