Pool Maintenance And Chemicals; Common Pool Problems - Intex 24 Owner's Manual

POOL MAINTENANCE & CHEMICALS
REMEMBER TO
• Protect all pool occupants from recreational water illnesses by keeping the pool
water clean. Don't swallow the pool water. Practice good hygiene.
• Keep your pool clean and clear. The pool floor must be visible at all times from
the outside barrier of the pool.
• Keep children away from pool covers to avoid entanglement, drowning, or other
serious injury.
The maintenance of proper water balance is the single most important factor to
maximize the life and appearance of the liner as well as ensuring clean, healthy, safe
water. Proper technique is important for water testing. See your pool professional for
chemical, test kits and testing procedures. Be sure to read and follow the written
instructions from the chemical manufacturer.
1. Never let chlorine come into contact with the liner before the chlorine has fully dissolved.
Granular or tableted chlorine is dissolved first into a bucket of water. Likewise, liquid
chlorine, if poured into various locations around the pool, must be immediately mixed
thoroughly with pool water.
2. Never mix chemicals together, rather add chemicals to pool water separately and circulate
throughout pool before adding additional chemicals.
3. An Intex pool skimmer and an Intex pool vacuum are available to assist in maintaining
clean pool water. See your pool dealer for these pool accessories.
4. Do not use pressure washer to clean the pool.
PROBLEM
ALGAE • Greenish water.
• Green or black spots
• Pool liner is slippery
COLORED • Water turns blue,
WATER
SUSPENDED • Water is cloudy or
MATTER IN
WATER
CHRONIC LOW • Level is lower than
WATER LEVEL
SEDIMENT ON • Dirt or sand on pool
POOL BOTTOM
SURFACE DEBRIS • Leaves, insects etc.
SAVE THESE INSTRUCTIONS
(87PO) ROUND METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 06/27/2008
WARNING
DESCRIPTION
• Chlorine and pH levels
need adjustment.
on pool liner.
and/or has a bad odor.
• Copper, iron or
brown, or black when manganese in water
first treated with being oxidized by the
chlorine. added chlorine.
Common.
• "Hard water" caused by
milky. pH level being too high.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner
on previous day. or hoses. Tighten caps.
• Heavy use, getting in
floor. and out of pool.
• Pool too close to trees.
CAUSE REMEDY
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Replace cartridge frequently.
• Correct pH. Check with pool
dealer for water treatment.
• Check for proper chlorine level.
• Clean or replace your filter.
• Repair with patch kit.
• Finger tighten all caps.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
English
87PO
Page 11