Panasonic VL-SWD501EX Operating Instructions Manual page 27

Function name
Motion detection range R Select the range (area) of motion detection.
Configuration
1. Touch areas that you do not want motion to be detected in so
2. Touch [Configure].
Recording before <1 second before>, 2 seconds before
detection
R Select to start recording 1 or 2 seconds before a sensor detection is made.
Check sensors Heat sensor, Motion detection, External sensor
R You can check the operations of each sensor when setting the camera, or at any
Recording test R Confirm if images are correctly recorded before and after images are recorded for
External sensor <Make contact>, Break contact
R When using commercially available external sensors, select the type of contact
*1 When [Day and night switch] is set to [Timer], the configured time periods are displayed above the [Night only]
and [Day only] setting buttons.
Item name: Screen settings
Function name
Brightness -3, -2, -1, <0>, +1, +2, +3
R Adjust the brightness of camera images. (The higher you set the brightness, the
Backlight compensation On, <Off>
R When [On] is selected, backlight compensation is performed. However, depending
Automatic illumination When the sensor is triggered: Enable, <Only when dark>, Disable
When monitoring: Enable, <Only when dark>, Disable
Uneven colour On, <Off>
prevention
R Normally use this setting set to [Off]. Only set this setting to [On] if the colour in
Item name: Sound settings
Function name
Sensor trigger sound Sound type: <Sound a>, Sound b, Sound c
Volume: <Loud>, Normal, Quiet, Mute
R Select the type and volume of the sound to be made by the camera when there is
Setting contents and other information
– By setting the areas that you do not want motion to be detected in to X, you can
narrow down the areas that motion can be detected in.
that X is displayed on those areas. (Touch again to remove
X.)
See page 23 for information about recording intervals and sensor detection
recordings.
other time.
– Select the type of sensor that you want to check, trigger it, and then confirm if
detections were correctly made. (See the Installation Guide for the camera for
information about how to check the sensors.)
sensor detections. (See the Installation Guide for the camera for more information.)
points used by the sensor.
– Select the type of contact point according to the external sensor used and its
function.
Setting contents and other information
brighter the image.)
– Make adjustments when the images are very dark or bright.
on the background of the subject, the backlight compensation may not be effective.
camera images is uneven. (When set to [On], the image quality may be reduced
when it is dark.)
Setting contents and other information
a sensor detection.
6. Using a camera
27