Bagging The Clippings; Installing The Grass Bag - Toro 20792 Operator's Manual

1. Lever
Note: To unlock the plug, rotate the lever on the plug
to the right (Figure 18).

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
A worn grass bag could allow debris to be
thrown and result in serious personal injury or
death to the operator or bystanders.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
Figure 18
2. Tabs
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before bagging the clippings.
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.

Installing the Grass Bag

1. Route the starter rope around the lower rope guide
(Figure 19).
1. Lower rope guide
Note: The lower rope guide releases the starter rope
when you pull the recoil start handle.
2. Raise and hold up the discharge deflector (Figure 20).
1. Discharge deflector
3. Pull out the rear discharge plug (Figure 20).
4. Hang the upper front edge of the bag on the notches
(Figure 21).
10
Figure 19
Figure 20
2. Rear discharge plug