Advertisement
Reading the Gauge
Setting up & using the Regulator
The gauge shows both PSI (Pounds per Square Inch) and BAR
(Atmospheric Presure at Sea Level) measurments.
These are indicated with 2 rings of measurement.
• BAR - Red
• PSI - Black
The gauge will allow you to setup the pressure accurately.
Pull the regulator up and turn valve clockwise to increase pressure
and counter clockwise to decrease pressure.
Using the Compressor
Using the Compressor with an Airbrush
• Connect the compressor to a mains outlet.
• Check the 3 way adaptor outlets are screwed on air tight.
• Attach the air hose to the compressor.
• Attach the airbrush to the other end of the air hose.
• Turn on the compressor.
• Set air pressure to 2-40 PSI on the compressor.
• Press down on the trigger of the airbrush and readjust the
regulator valve to the required output pressure level.
Please Note:
Always check your equipment for damage and leaks before use.
6
After Sales Support
UK/N.IRELAND HELPLINE N
WEBSITE:
www.airbrushheaven.co.uk
EMAIL:
enquiries@airbrushheaven.co.uk
:
01270 508530
O
Hide quick links:
Advertisement
