Seat; Fueling; Release Lever - McCulloch M125-85F Operator's Manual

The transport position is activated as follows:
1 Press down the lifting pedal for the cutting deck.
2 Press in the lock button on the steering column.
3 Release the lifting pedal while keeping the button pressed
in.
If the lifting pedal is released without pressing in the lock
button, the cutting deck will be lowered to the mowing
position.
The pedal can also be used to temporarily adjust the cutting
height, such as when passing a minor bump in the lawn.
Operation of blades.
Loosen the lever, move it forward and the blades start to
rotate.
Move the lever back and lock it to stop the blades from
rotating.
Cutting height adjustment lever
The cutting height can be adjusted to 5 (1-5) different
positions with the cutting height lever.
Position 1 indicates the lowest cutting height and position 5
the highest.
Never use position S when mowing. Position S is the service
position.
PRESENTATION

Seat

The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
Loosen the bolts under the seat and adjust it forwards or
backwards to the desired position.

Fueling

The engine runs on unleaded petrol with a minimum octane
rating of 85 (not mixed with oil). We recommend the use of
biodegradable alkylate petrol.
Allways use fresh and clean, unleaded petrol. Do not use
petrol that contains methanol.
Do not fill the tank completely, leave an expansion area of at
least 2.5 cm (1").
!
IMPORTANT! Do not use the fuel tank as a support area.
Release lever M125-85FH
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff. Pull the
controls to the end positions, do not use an intermediate
position.
• Turn off the motor.
• Pull out the control to disengage the drive system.
• Push in the control to engage to the drive system.
WARNING! Petrol is highly inflammable.
Exercise care and refuel outdoors (see
safety instructions).
– 13
English