Selecting A Power Source; Connecting Via The Ac Power Cord; Using The Device On Batteries - LENCO SCD-38 USB User Manual

Selecting a power source

You can use the AC power outlet or batteries as a power source.
Note: Batteries are not included.

Connecting via the AC power cord

Insert one end of the supplied AC power cord into the AC IN socket located at
the rear view of the player, and the other end to the wall outlet.
Note: If the plug of the AC power cord does not match your outlet, do not force it.
Reverse it and try again. The plug is polarized and only fits one way into the wall
outlet and rear of the set.

Using the device on batteries

Important: Remove the AC power cord while operating the unit on batteries.
Notes:
-Lenco recommends the use of A-Brand batteries.
-Replace the batteries when the POWER LED dims or when the player
stops operating.
-If the CD does not play, this means that the batteries are almost empty.
Loading the batteries:
1. Roll over the unit so that the
battery
becomes accessible.
2. Use one finger to press the
sagging block towards the
arrow on the battery cover
and then push the cover to
the arrow until hearing a click,
now hold the front edge of the
cover and turn up to remove it.
3. Place 6 size "C" batteries into
the battery
according to the direction of
"+" and "-"electrode marked
inside of
compartment.
4. Place the buckle of the cover
towards the buckle groove and place the 4 legs of the cover face to the leg
grooves to wedge the cover onto the player and then push it into previous
position to close it.
compartment
leg groove
compartment
leg groove
the battery
leg
leg
sagging block
10
leg
leg
buckle
leg groove
leg groove
buckle groove