Installation & Connections - LIDA CF11550 Owner's Manual

Installation & Connections
Please observe the following steps before
installation:
• P lease pull off the wooden pallet down
the fridge by unscrewing the two fixing
screws (figure 1).
(figure 1)
• C lean the fridge from the inside and the
outside with a wet warm cloth and with
a little amount of liquid soap, then dry it
well with a soft cloth.
• A void installing the fridge near any ther-
mal source, or any place exposed to di-
rect sunshine or extra humidity.
• I nstall the refrigerator in a dry, well ven-
tilated, moderate place.
• M ake sure of the proper replacement of
the fridge on a flat bottom surface, as
you have also to adjust the front regu-
lating foot (figure 2) in a way making
it horizontal and inclined backwards to
ensure proper door closing.
• P lease install the fridge with adequate
space (at least 10 cm) between the up-
per surface of the fridge and the oppo-
site surface, as well as between the side
and back surfaces.
• I n a case that the fridge is placed next to
a freezer or another fridge, please make
sufficient space between them to pre-
vent condensing.
(figure 2)
Electric connections:
• F or safe and good work, it is preferable
to install a 16 Ampere circuit breaker
special for the fridge.
• A fter installation please make sure that
the fridge is not placed on the power
cord.
• T he electric current connection should
be in accordance with the local electric
power supply net.
• T he electric system should be supplied
with an electric ground line according
to the standard local systems, and the
company will not be responsible for any
accident or damage could happen to in-
dividuals due to the fact that they did
not follow the above mentioned instruc-
tions.
• I n the electric connection do not use
any connections, wires, converter plugs
...etc.
• D o not break the third polar (ground) of
the power plug.
• D o not bend the power cord.
• D o not try to insert the power plug of
the refrigerator in the socket with a wet
hand.
- 5 -