Do you have a question about the DN-961FA and is the answer not in the manual?
Questions and answers
Paul A Millar
April 6, 2025
How to replace drive belt.
1 comments:
Mr. Anderson
May 14, 2025
To replace the drive belt on a Denon DN-961FA, follow these steps:
1. Remove 7 screws securing the jack bracket and disconnect each connector wire. 2. Remove one screw (201) on the Side Panel L. 3. Disconnect the connector wire from the DC Power Unit. 4. Detach the DC Power Unit from the two locking card spacers. 5. Access the Clamp Arm Sub Assembly by removing the Clamp Arm Base. 6. Use the Insert Jig between the Clamp Arm Base and the Roller Shaft. 7. Align the Clamper Jig with the Turntable center by eye. 8. Secure the Clamp Arm Base with the fixing screw. 9. Remove the two Jigs. 10. Ensure the Clamper and Clamper Arm do not touch the disc when rotating.
Then install the new belt onto the drive mechanism.
Need help?
Do you have a question about the DN-961FA and is the answer not in the manual?
Questions and answers
How to replace drive belt.
To replace the drive belt on a Denon DN-961FA, follow these steps:
1. Remove 7 screws securing the jack bracket and disconnect each connector wire.
2. Remove one screw (201) on the Side Panel L.
3. Disconnect the connector wire from the DC Power Unit.
4. Detach the DC Power Unit from the two locking card spacers.
5. Access the Clamp Arm Sub Assembly by removing the Clamp Arm Base.
6. Use the Insert Jig between the Clamp Arm Base and the Roller Shaft.
7. Align the Clamper Jig with the Turntable center by eye.
8. Secure the Clamp Arm Base with the fixing screw.
9. Remove the two Jigs.
10. Ensure the Clamper and Clamper Arm do not touch the disc when rotating.
Then install the new belt onto the drive mechanism.
This answer is automatically generated