Advertisement

Classic Series Public Address Amplifiers
C10 & C20 Models
Installation and Use Manual
© 2009 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-5978-01B 0901

Advertisement

Table of Contents
loading

Summary of Contents for Bogen C10

  • Page 1 Classic Series Public Address Amplifiers C10 & C20 Models Installation and Use Manual © 2009 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-5978-01B 0901...
  • Page 2 Notice IMPORTANT Every effort was made to ensure that the information in this guide was complete and accurate at the time of printing. However, information is subject to change. Important Safety Information CAUTION: TO PREVENT THE RISK OF WARNING: To Reduce The Risk of Fire Or Electric Shock, ELECTRIC SHOCK, DO NOT REMOVE COVER Do Not Expose This Apparatus To Rain Or Moisture.
  • Page 3: Table Of Contents

    Contents DESCRIPTION ........................4 FRONT PANEL........................4 REAR PANEL ........................5 INSTALLATION........................5 Power and Grounding ........................5 Input Connections ..........................5 Microphone Connections ......................5 Microphone Precedence ........................5 AUX ..............................5 TEL ..............................5 Output Connections ..........................6 Speakers, General ..........................6 OPERATION ........................6 POWER ............................6 MIC1, MIC2 ..........................6 AUX ..............................6 TEL ..............................6 VOX SENS ............................6 Microphone Precedence ........................6...
  • Page 4: Description

    Description Bogen Models C10 and C20 public address amplifiers are rated at 10 and 20 watts, respectively, and are UL and C-UL listed. The amplifiers accommodate low-impedance microphones and high-impedance auxiliary sources. A front panel selector switch offers a choice of either two low-impedance balanced microphones (MIC1, MIC2), or one micro- phone and one auxiliary input (MIC1, AUX).
  • Page 5: Rear Panel

    Rear Panel 1. Amplifier Output Screw terminal strip containing all available speaker outputs. 2. Mute Input Screw terminal input for microphone precedence. 3. MIC1/MIC2 Screw terminal input for Lo-Z balanced microphone signal. 4. AUX Power A grounded, unswitched AC convenience receptacle with 300W maximum capacity is provided for external equipment. 5.
  • Page 6: Output Connections

    Output Connections Speakers, General The amplifier may be used with most conventional speaker systems. Connect one speaker lead to the screw ter- minal that corresponds to the total impedance or proper voltage of the speakers used in the system and the other lead to the COM terminal.
  • Page 7: Accessories

    • Jumper selection allows line level signal to microphone level signal conversion RPK35B - Rack Panel Kit • RPK35B adapts Classic Series amps (Models C10, and C20) for 19" rack mounting, 2 rack spaces (3-1/2") • Heavy gauge steel construction WMK1 - In-Wall Mounting Kit •...
  • Page 8: Limited Warranty

    State to State. Products that are out of warranty will also be repaired by the Bogen Factory Service Department -- same address as above or call 201-934-8500. The parts and labor involved in these repairs are warranted for 90 days when repaired by the Bogen Factory Service Department.

This manual is also suitable for:

C20

Table of Contents