Samsung WA10J8700G Series User Manual page 29

07 Activ Dual
Wash Drain
08 Last Setting
09 Pre Soak
10 Delay End
11 Wash
12 Rinse
13 Spin
14 Start/Pause
15 Power
WA8700J_WA10J8700GP-03520B-03_SA.indd 29
This button provides two options, and is available only when the
washing machine is stopped or in Standby state.
• Water Save (default): Reuse water in the tub that remains
after using Water Jet. The water will be used for the main cycle.
• Drain: Select to drain water that remains after using Water Jet.
When draining is complete, the washing machine switches to
Water Save mode automatically. Then, you can choose a cycle.
Selects this cycle to load the settings for the last cycle.
Perform a wash cycle using the last used settings without having
to enter them manually again. Your choices are automatically saved
when you press the Start/Pause button. To use a memorized cycle,
press the Last Setting button and then press the Start/Pause button.
Remove stains more thoroughly by specifying additional time.
Delay the end of any cycle for up to 19 hours in one-hour increments.
Displayed hour indicates the time the wash will be ended.
Press this button to only perform a wash cycle or to adjust the wash
time.
Press this button to only perform a rinse cycle or to adjust the rinse
count.
Press this button to perform a spin cycle only or to adjust the spin
time.
You can set the spin time from between 1 to 9 minutes. (except for
WATER SAVING )
When only a spin is selected, the spin time will be different from the
total remaining time. This is because the total remaining time includes
the actual spin time and the times for water draining and stopping.
Press to pause and restart cycles.
Press once to turn your washer on. Press again to turn your washer
off. If the washer is left on for more than 10 minutes without any
buttons being pressed, the power automatically turns off.
English 29
2015/7/25 11:29:26