Advertisement
to clear
ratchet tooth.
4. Insert a narrow,
flat-blade
screwdriver
under the timing cam
near the clock shaft. Gently lift cam
stralght up and off shaft maklng
sure
that the "V-shaped
notch clears the
ratchet
tooth.
5. Place new cam (hub side down)
over clock shaft. Line up flat side of
shaft with flat side of cam hole.
Check that drive lug is in place,
6.
Turn cam until "Y-shaped
notch
lines up with ratchet
tooth.
7. Press cam down in place
on motor
shaft. Make sure that Y-shaped
notch clears the ratchet
tooth,
8.
Reattach
the timer bracket
assembly;
tighten
the screws.
9. Repeat
steps for other timer.
10.
Close and lock the control
panel.
Now start...
With dryers in laundry area.
1
n
Put on gloves and safety glasses.
Check that each leg is approximately
2.5 cm (1 inch) from base.
2.
Wipe the interior of the drums
thoroughly
with a damp
cloth.
3.
Install coin vaults and locks (not
supplied)
into meter case openings.
4.
Install control
panel lock and key (not
supplied).
5.
If you wish to change
the 45-minute
dryer timing cams to either 30- or 60-
minute timing cams, see "To change
to a 30 or 60-minute
timlng cam,"
Pages 7 and 8. Complete
all of the
steps given in that section
before
going to Step 6.
Open control
panel
and rest it on the
bottom
edge of the opening.
Attach
slide extension
(with flange
pointing
down)
to one of the coin-slide
mechanisms.
Insert the coin-slide
mechanism
through
the opening
to
the left of the control
panel.
7.
Secure coin-slide
mechanism
from
inside the control
panel
using the
3/16" bolt and washer supplied.
Install
coin box.
8.
Repeat
Steps 6 and 7 for the other
coin-slide
mechanism.
Close control
panel,
l
i
9.
Insert top of wire guard
into holes on
each side of the coin-slide
mechanism.
Insert screws through
hooked
ends of guard
and tighten.
Repeat
for other wire guard.
Page 8
Advertisement
