Foxconn P9657AA Manual page 43

vMODEM Use IRQ
This option is used to set the IRQ in which the modem can use.The system
will automatically wake up when the modem receives an incoming call. In
order for this function to work, the Fax/Modem must be connected to the W OM
header on the motherboard.
vSuspend Mode
This option is used to set the idle time before the system enters into sleep
status.
vHDD Power Down
This option is used to turn off hard disk power if the hard disk is idle for a given
period of time.
vSoft-Off by PWR-BTTN
This option is used to set the power down method.This function is only valid
for systems using an ATX power supply.
vCase Open Warning
This option is used to enable or disable case open warning function.
vWake- up by PCI card
This item is used to set the system to wake up by PCI card.
vPower On by Ring
If this item is enabled, it allows the system to resume from a software
power down or power saving mode whenever there is an incoming call to
an installed fax. This function needs to be supported by the relevant
hardware and software.
vWake up On LAN
This item is used to set the system to wake up On LAN.
vUSB KB Wake-Up From S3
This item is used to set the system to wake up by USB equipment when it is
in S3 (Suspend to RAM) mode.
vResume by Alarm
This item is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be canceled. Also, the PC power
source must not be turned off. The setting values are: Disabled and Enabled.
36
Chapter 3 BIOS Description